V8a-flashme-noauto -

Example session:

| Command | Purpose | |---------|---------| | part show | List current partition table | | part create gpt | Create GPT table (manual) | | write bootloader u-boot.bin 64 | Write bootloader at offset 64KB | | write kernel Image 0x200000 | Write kernel at 2MB offset | | write rootfs rootfs.img 0x800000 | Write rootfs at 8MB offset | | verify all | Checksum verification | | exit | Finish (does not reboot) | v8a-flashme-noauto

lsblk Look for your SD card or eMMC (e.g., /dev/mmcblk0 , /dev/sdb ). Example output: Example session: | Command | Purpose | |---------|---------|

> part set bootable rootfs > write bootloader u-boot.bin 64 | Feature | v8a-flashme-auto | v8a-flashme-noauto | |---------|--------------------|----------------------| | Partitioning | Automatic | Manual ( part create ) | | Bootloader install | Yes (fixed offset) | Manual | | Rootfs write | Yes | Manual | | Reboot after flash | Yes | No | | Risk level | Low (if defaults match) | High (user must know offsets) | Step 3 – Manual operations (inside the flasher

mmcblk0 179:0 0 14.6G 0 disk # ← target storage sudo ./v8a-flashme-noauto --device /dev/mmcblk0 🛑 The noauto flag means it will not partition, format, or install a bootloader automatically. You will see: Waiting for manual commands... Step 3 – Manual operations (inside the flasher shell) Once the flasher is running, you get an interactive prompt. Typical manual commands: